I need a fixed, read-only ID
TM1990A-F5
Check the reader or controller model and firmware before ordering.
Reference priceUS$0.25–0.50 per piece
Reference price includes a plastic handle.
Bulk order minimum500 pieces
Full Touch Memory / 1-Wire range. Tell us your model, volume and any marking or packing needs; feasibility and cost are confirmed in the quote.
Start with the ID: fixed at the factory, or writable with your equipment.
For these two models: 10 free sample pieces, ready in 3 days; you pay sample shipping. 500 pieces are usually ready in 1 week. Transit time is additional.
I need a fixed, read-only ID
Check the reader or controller model and firmware before ordering.
Reference priceUS$0.25–0.50 per piece
Reference price includes a plastic handle.
Bulk order minimum500 pieces
I need to write or rewrite an ID
Confirm writer support for the supplied blank version. Test writing, rewriting and acceptance by the target system.
Reference priceUS$0.26–0.55 per piece
Reference price includes a plastic handle.
Bulk order minimum500 pieces
Not sure which key your system needs?
Ask us to check compatibility →Read-only 64-bit ROM keys for access-control and intercom projects.
A 64-bit ROM key in the F5 can, built to the DS1990A format.
Same Ø16.25 mm diameter as the F5 in a slimmer 3.1 mm F3 can for flush mounting.
R-variant; the original manufacturer's datasheet describes a presence pulse on contact with a live bus.
Fixed-ID Touch Memory key for equipment and access-control projects.
DS1990A key pre-assembled into a magnetic-ring key fob.
Standard fob assembly without the magnet ring.
Programmable blanks for key-cutting shops and duplicating services.
A rewritable TM blank for duplicating services.
RW1990.2 blank; confirm its version and required write procedure.
One-time-programmable blank; confirm the source key and target equipment before ordering.
Multi-format blank; confirm the supplied version and your duplicator's support.
Rewritable blank with memory area for extended-format keys.
OTP blank for Cyfral and Metakom keys: written once, then locked.
NV RAM / EEPROM devices from 1 Kb to 64 Kb, including SHA-1 authentication parts.
Three password-protected 384-bit subkeys in one button.
1 Kb and 4 Kb NV RAM tokens for carrying data on the key.
The large-memory token — 64 Kb of rewritable NV RAM.
1 Kb EEPROM with on-chip SHA-1 challenge–response.
256-bit EEPROM — non-volatile without a battery.
1 Kb add-only EPROM for records that should not be altered.
Self-contained Thermochron / Hygrochron loggers for cold-chain and process monitoring.
A cold-chain logger: 2048 timestamped readings plus a built-in histogram, −40 to +85 °C.
±0.5 °C accuracy and 0.0625 °C resolution per the datasheet, sampling as fast as once per second.
Logs relative humidity — 0–100 % RH alongside temperature, from one stainless can.
Up to 125,440 timestamped readings per the datasheet — 15× the DS1922L, enough for a year-long mission at one point per 5 min.
Contact probes, panel-mount readers and USB 1-Wire masters.
Chrome-plated copper probe with pre-wired leads — the minimal front-end.
The TMR-01 with a polymer guide ring — the ring helps guide the key onto the contact.
DS9092-format panel probe with M18×1 nut and 200 mm leads — a familiar front end for controllers.
The TMR-02 with a built-in LED — four wires, so the controller can light the ring on a valid read.
A permanent magnet holds the key on the contact — designed for reads with no pressure and no aiming.
Copper contacts in an ABS capsule — designed to keep the key ground off the panel.
Fob holders, magnetic rings and panel sockets to finish the installation.
A snap-in plastic fob for F5 iButtons.
Illuminated receptor socket for door panels and gates.
Wearable TM credential for wet and high-turnover venues.
Stitched leather fob for hotels, offices and premium issuance.
Compact teardrop fob — smaller than a standard holder.
A POM key-fob holder; colours are confirmed in the quote.
Card-format Touch Memory, including dual TM + RFID credentials.
125 kHz T5577 rewritable fobs and epoxy tags, plus UID-changeable 13.56 MHz tags — the contactless side of a mixed estate.
Handheld copiers and bench programmers for TM and RFID credentials.
One handheld unit copies both contact TM keys and 125 kHz RFID fobs, with the ID on an LCD.
One-touch copier — no PC and no menus.
Battery programmer with screen, memory and PC upload.
1-Wire key ICs for other key manufacturers; die or packaged formats are confirmed in the quote.
Battery-powered cabinet locks opened by a TM 1990 key — for gyms, spas, lockers and furniture.
Plastic-front locker lock opened by a TM 1990 key.
Slim plated zinc-alloy lock for furniture and display cases.
Toughened-glass front with a panel designed to carry printed artwork.
Stainless rim lock, one master plus 1000 sub-keys.
56 models · 11 Product categories